Study guide · Tides and electronic navigation
Understanding tides, depth of water and electronic navigation
In the North Sea the water rises and falls by several metres twice a day. Anyone sailing there must know how much water is under the keel right now and where the tidal stream is setting. The Baltic has hardly any tides, but the wind changes the water level instead. On this page you learn how tides arise and how to work out depths from the chart and the tide tables. You also learn what to watch out for with GPS, radar and AIS. As a running example you plan a passage through the Wadden Sea. The page is based on the official question catalogue for the German Coastal Skipper's Certificate, but it is written in our own words.
How tides arise
Tides are caused mainly by the pull of the moon and, to a lesser extent, by the sun. In the North Sea there are roughly two high waters (HW) and two low waters (LW) a day. The difference in height between them is called the range of the tide.
Seen from the earth, the moon takes on average 24 hours 50 minutes to come round again. This is the lunar day. High and low water therefore arrive about 50 minutes later each day. On some days the last high water slips into the next day. The tide table then shows only one high water for that day.
Spring tides and neap tides
How strong the tides are depends on how the sun and the moon stand in relation to each other.
- At full moon and new moon, the sun, the moon and the earth are roughly in line. Their pull adds up. These are spring tides: very high high waters, very low low waters, a large range and strong tidal streams.
- At half moon, the sun and the moon, seen from the earth, are at right angles to each other. Their effects partly cancel out. These are neap tides: low high waters, high low waters, a small range and weaker streams.
Spring tides do not occur exactly on the day of full or new moon, but usually one to two days later. The age of the tide tells you in which phase between neaps and springs the tide currently is.
Wind and air pressure
The tide table works out water levels from the moon and the sun. It does not include the weather. Strong wind and very high or very low air pressure can change the actual water levels considerably. Wind also creates currents that add to the tidal streams.
- An onshore gale pushes water against the coast. High and low water are then higher. This is called wind set-up.
- An offshore wind pushes water away from the coast. Water levels are lower.
- High air pressure pushes the sea surface down, low air pressure lets it rise.
In such weather the times of high and low water can also shift.
In the Baltic, tides hardly matter. There, wind and air pressure determine the water level. After days of high pressure and a strong offshore wind, the depth of water can be well below the charted depth.
Chart datum and charted depth
The depth figures on a chart need a fixed reference level. This level is called chart datum (KN in German charts). What the depths of a chart refer to is stated on that chart.
- In the Baltic, chart datum is mean water level.
- In the North Sea and the English Channel, chart datum is the lowest astronomical tide (LAT).
The depth figure on the chart is the charted depth. It is the depth of water at chart datum. Because chart datum in the North Sea is so low, the water normally does not fall below it. You can therefore normally count on at least the charted depth. Wind and air pressure can change this, as the previous section shows.
An underlined depth figure means something different. It shows how high the spot lies above chart datum. This spot dries at low water. An underlined 2 with a small subscript 3 therefore means the seabed lies 2.3 metres above chart datum.
Working out the depth of water
The height of tide (H) is the water level above chart datum at a given time. You take it from the tide tables. In many harbours a tide gauge also shows the current water level, a fixed scale.
This gives you the actual depth of water.
depth of water = charted depth + H
The other way round, charted depth = depth of water − H. This is how you reduce a sounding to the charted depth. For a drying spot you enter its height above chart datum with a minus sign.
- Read the charted depth at the spot you want to pass.
- Take the height of tide for your time from the tide table.
- Add the two. This is the depth of water.
- Subtract your draught. What remains is the water under the keel.
Often you ask the question the other way round: how much tide do I need at least? Then you add draught and the clearance you want and subtract the charted depth.
Sounding in tidal waters
A sounding applies only to the moment you take it. If you sound outside low water, the depth will be less at the following low water. That is why you note the time with every sounding. With the tide table you can then see whether the water is rising or falling and how deep it will be later.
Tidal streams
With the water level, the current changes too. Tidal streams change direction several times a day. At spring tides they run much stronger than at neaps.
You find information on tidal streams in coastal waters in three places.
- In tidal stream atlases. They show the stream for every hour before and after high water at a reference port.
- In the tidal stream tables on the chart. They apply to the points marked on the chart with a letter in a diamond.
- In the sailing directions.
These tables refer to the time of high water at a reference port, for example Helgoland. First you work out how many hours before or after this high water your time lies. Then you read off the matching row.
GPS and DGPS
GPS stands for Global Positioning System. The receiver measures how long the signals from several satellites take to reach it. From these travel times it calculates the distances to the satellites and from them the position. GPS works worldwide, the position is always available and the error is small.
Accuracy is given with a probability of about 95 per cent. A GPS position is typically accurate to 10 to 20 metres. DGPS improves this to 1 to 10 metres. Fixed reference stations ashore send correction values to ships by radio.
Expect inaccurate readings when the antenna is shaded, and near airports, television transmitters and naval installations. The antenna therefore needs a clear view all round and must be properly earthed.
You can tell whether a position is reliable from three things.
- From the HDOP value. It describes how favourably the satellites are spread across the sky. The smaller the value, the better.
- From the number of satellites received.
- From a comparison with the DR position and with bearings or soundings.
Chart datum, waypoint and MOB button
GPS works in the worldwide reference system WGS 84. Many older charts are based on a different horizontal datum. GPS position and chart can then be several metres to more than a hundred metres apart. You have two options. You set the receiver to the horizontal datum of the chart. Or you shift the GPS position by the correction given on the chart.
A waypoint is the set of geographical coordinates of a point you want to steer for. The receiver shows you the bearing and distance to it.
When you press the MOB button, the receiver stores the position at the moment you pressed it. It then shows the true bearing and the distance to this position.
Radar
With radar you measure ranges to targets. For this you set the variable range marker, VRM for short. You read the direction with the electronic bearing line.
If you measure only two ranges, you get two range circles. They usually intersect at two points. A bearing, a third range or the DR position must decide which point is right.
Small craft and buoys can "disappear" from the screen. The reasons are sea clutter or rain, too great a range and, in the head-up display, the yawing of your own boat. If two targets lie close together, such as two buoys or two pier heads, their echoes easily merge. A short pulse length and a smaller range scale help.
AIS
AIS stands for Automatic Identification System. Ships use it to transmit their identity, position, course and speed over ground and their navigational status by radio. The range depends above all on the antenna height.
AIS only shows ships that transmit themselves. A ship in sight may be missing for three reasons. It may have no AIS or may have switched its set off. Or too many ships are overloading the system in the area.
Some AIS data is entered by hand by the crew, for example the navigational status. It can be out of date.
The essentials in brief
- A lunar day lasts on average 24 hours 50 minutes. High and low water come about 50 minutes later each day.
- Spring tides: sun, moon and earth in line, large range, strong streams. Neap tides: right angle, small range.
- Wind and air pressure can change water levels and times considerably. In the Baltic they determine the water level.
- Chart datum is mean water level in the Baltic and LAT in the North Sea and the English Channel.
- Depth of water = charted depth + H. Subtract your draught from the result.
- Underlined depth figures show how high a drying spot lies above chart datum.
- Every sounding needs its time. At the next low water it will be shallower.
- Tidal stream information is found in stream atlases, tables on the chart and sailing directions. It refers to HW at a reference port.
- GPS is accurate to 10 to 20 metres, DGPS to 1 to 10 metres. HDOP and the number of satellites show reliability.
- The chart must match the datum of the GPS. The MOB point is fixed over the ground.
- You measure ranges on radar with the VRM. AIS only shows ships that transmit.
Terms
- High water
- The highest water level of a tide.
- Low water
- The lowest water level of a tide.
- Range
- The difference in height between high and low water.
- Lunar day
- The average time of 24 hours 50 minutes after which the moon is back in the same place.
- Spring tides
- The period with a particularly large range, shortly after full and new moon.
- Neap tides
- The period with a particularly small range, shortly after half moon.
- Age of the tide
- The indication of the phase between neaps and springs the tide is in.
- Wind set-up
- A water level raised by wind at the coast.
- Tide gauge
- A scale that shows the water level.
- Chart datum
- The reference level for the depths on a chart.
- Charted depth
- The depth of water referred to chart datum.
- Height of tide
- The water level above chart datum at a given time.
- Tidal stream atlas
- A set of charts showing the tidal stream for each hour around high water at a reference port.
- DGPS
- GPS with correction values from reference stations ashore.
- HDOP
- A measure of how favourably the satellites are spread.
- WGS 84
- The worldwide reference system in which GPS works.
- Waypoint
- The coordinates of a point you want to steer for.
- VRM
- The variable range marker on radar for measuring ranges.
- AIS
- A radio system with which ships transmit identity, position, course and speed.